Thursday, August 13, 2015

Spare Wheel: DIY Truing Stand, Part 1

First step to building the truing stand is to see if I can get the wheel nice and tight on the axle using the spacers I have.  By adding in a few 12mm washers, I got the rear wheel locked in perfectly.

Ended up using the stock "H" spacer on the right.  On the left used the axle sleeve + 3 washers + stock block washer.

Did a little truing just by holding the swingarm up with one hand.  Next step, build a platform to hold the swingarm up!




No comments:

Post a Comment