Showing posts with label Flexhone. Show all posts
Showing posts with label Flexhone. Show all posts

Saturday, December 21, 2019

Red: Hard Hone

Figured that if changing the rings made absolutely no difference, then it must be the cylinder itself that was at fault.  I remembered seeing score marks (running straight down the length of the cylinder) last time it was out.

So pulled the jug off again today.  Checked the piston gap on the top ring and it was well within spec at .254mm to .305mm.

But definitely saw the same straight line score marks.

Tried going at it with the 48mm Flexhone to try to smooth it out, but that didn't seem to do much.  Switched to the bigger 51mm which was tricky to keep moving at a constant speed (it kept getting stuck) but eventually got to a rhythm once the balls had worn down a bit.

Couldn't really smooth out the scoring, though, so they must be in there pretty deep.

On start up, there was no smoke, but I only let it idle for a minute as I want to seat the rings before anything.  The lack of smoke may just be because the oil hasn't had a chance to work its way up into the chamber yet.

We'll have to see after we do a few runs.




Saturday, October 6, 2018

Flexhone Practice, Round 2

Second shot at Flexhone practice on the extremely rusty jug.  Good experience, if only to understand the limits of what the Flexhone is and isn't capable of.

Also lubed Ivy's chain.





Thursday, September 27, 2018

Run Red Run: First Flexhone practice

First Flexhone practice run.  It was at the same time not as difficult as I thought but also harder to get right.

The doing was easy enough: heavy dose of the oil on the Flexhone and in the cylinder.  Didn't realize it would be quite so messy as there was overspray everywhere.

The lightly rusted surface of the CT90 practice jug cleaned up very, very nicely considering it was my first shot, but I really couldn't get anywhere close to the crosshatching that I had seen in pictures.

Not sure if that was because the Flexhone was maybe a bit too small for the diameter of the jug?  But it only came in the 49 and 51 mm increments with nothing in between, and the 51 mm simply wouldn't fit.









Friday, August 24, 2018

Run Red Run: Odd Jobs

A few odd jobs on a half day-off...


  • Mounted the headlight... you have to install the mounts before the light itself!
  • Added the new taillight to the rear fender (using the extra holes drilled into it).  Then mounted the fender itself.  Nice!
  • Pulled Astrid out for the first time in ages.
    • Pumped up the tires which were flat.
    • Checked to see if gas was flowing.  Discovered that it would flow in Reserve, but nothing flowing out when switched full on.  Figured there was a clog in the filter.  Only when packing up did I bother checking the gas level and saw that it was way below the inlet pipe so of course only the Reserve would work!  Dumb, dumb, dumb...
    • Also realized/remembered that the big reason you can't run a full on S90 head on the CM91 is because the frame blocks the intake/carb.  So you can run the top end but you still have to use the CM91's carb/air filter.
  • Checked the sizing of the new 48mm Flexhone in the CT90 jug and it looked like a good fit.