Ivy Bike Stand, Round 2

Realized that it would be ideal to be able to slide the stool further over to the right, but that means it needs a groove for the oil bolt to slide into.

Used the Dremel attachment to set the right height and then just start cutting.

Theory worked out, but it's slow work.  Ended up doing about 4-5 cm's worth.  It's enough to get the stool solidly underneath the engine, but not enough to be able to bolt in the right side peg bolts.

Not sure if it's worth it to do that, though.

Maybe will just cut the holes for the two left-side bolts and then do a test to see if the other two are really needed.

Also did a test on the neutral wire.  Oddly, found that when in neutral, testing from the wire to battery positive resulted in a very slight voltage, but definitely not enough to power the bulb.  Not sure why there was some voltage but not a full 6v.