The fork bridge seemed like as good a place as any to start. I sanded down what I could on the top side, which was pretty straight forward. But the underside is full of narrow nooks and crannies. I gave the Dremel a shot, but there were still too many hard-to-reach places. So finally, I just gave it an Evapo-Rust bath for 24 hours. As usual, that worked wonders.
The Before...
After day one of sanding the top.
Day two, looking to attack the underside with the Dremel. (7/1)
Couldn't quite reach those nooks and crannies with the Dremel brush.
So she goes in for a dip.
And the After...
Day three, priming (7/2)
No comments:
Post a Comment