Monday, April 28, 2014

Roxy: DIY 5mm Screws Tested

Somewhat shocked to find the screw worked.  And I was able to thread it with my fingers the entire length.  It did cinch down tight at the end, though.  I'm wondering if that's too loose...?

Then I cut 3 more screws to see how the die would hold up.  By the 3rd one (4th overall) it was getting a bit hard to get the screw to bite in at first.  Also seemed like the screw was turning crookedly.

Yet the finished screw looked good, with clean threads at the right pitch.

It would be perfect if these socket screws weren't hardened alloy, but they don't seem to sell them any other way.  And I can't find regular pan heads in #12-28 either.

Still, if you could cut a half dozen screws before the die gave out, you'd still come out a little ahead of eBay.



No comments:

Post a Comment