Friday, May 27, 2016

S90 Special Tool

Nabbed this vintage S90 "Special Tool" case on eBay for $41.  Was back and forth on whether to restore it or leave it with the (pink) patina.  But in the end, I wanted to to keep it inside so had to have it looking fresh and clean.








Tuesday, May 24, 2016

Blue: Horn Grills in Orange

The chrome on the horn grills had started to look plain horrible (pits and corrosion), to the point where it was nagging me.  At $50 each, decided I may as well try to do something with the existing ones.  Sanded them down hard with 80 grit then painted them in orange (engine paint).

Looked good in my imagination, but not really sure how much I like it in reality.  Jury's still out...









Monday, May 16, 2016

Spares: Rear Sprocket Cover Paint

Painted one of the spare rear sprocket covers (the one in the worst nic) in cast coat aluminum, intending to put it on the model engine.  But didn't like how it covered up the detail of the rear sprocket so just ended up putting it back in storage.

Came out very nice, though...




Sunday, May 8, 2016

Blue: Ashtray restore

Thought it would be nice to have some kind of tray to put the garage opener in while driving, but the glovebox is too far to reach while strapped in.  Ashtray was perfect, but in crappy shape, so did a sand/paint job and came out better than expected.

Took the black paint off the chrome trim and left it bare.






Friday, April 29, 2016

Astrid: Oil Leaks

Noticed there was some oil leaking from the rocker cover.  When I popped it off, I found that it was still the original gasket (not one I'd replaced during the rebuild).  It looked pretty tough to scrape off, so I swapped it with the one on Ivy, which had an old gasket too, but one that came off pretty easily.

Replaced it with a new one from the gasket binder.  No more leak.  Job done.

But... it's still clear that there's a leak where the head meets the cylinder jug.








Motor: Gasket Check

Spent time just poking around Ivy's bottom end (which is currently mounted in Red), just making notes and observations.

  1. Need case screws on both sides
  2. Need 1 x clutch inner cover screw
  3. Do I need to install the clutch lifter?
  4. Torque the clutch nut
  5. Torque the oil bolt
  6. Torque or tighten the engine mount bolts
  7. Have both the alternator and clutch cover gaskets (but only 1 clutch cover gasket in stock so just ordered another set)

On the fence about whether to try to get the engine running while it's still mounted in Red.  This would involve a temporary mounting solution for the exhaust and I may have to install the stock handlebars so the throttle cable fits.  And those are only the things I know about...

Or is it easier to just try to mount the engine into Ivy now?




Astrid: K&N

The K&N RU-0155 (38mm OD) was a perfect fit for the CM91 carb.  And more importantly, she actually ran with it.  But I actually started it with the normal airbox, let it warm up, then switched to the K&N.

What I discovered a few days later is that while she'll run with the K&N, she doesn't seem to be able to start with the K&N.  Must simply be too much air when the engine's cold (even choked).

Interesting...