Friday, January 12, 2018

Ivy: Bad Clutch Cable Adjustment

Came down to start Ivy and found the kicker would barely move.  Almost like the bike was in gear (though it wasn't).

Finally realized the clutch cable was WAY out of adjustment.  But was confused, since I'd definitely started and run the engine after the oil change.

Can only think that I changed the cable adjust AFTER starting the engine without realizing I was mis-adjusting it.

Lesson learned: take clutch cable measurements before the oil change and double check it is reset afterwards.


Tuesday, January 9, 2018

Ivy: Oil Change

Ivy oil change.  Mesh filter was pretty clean, just a bit of "fuzz".

Added 650mL of oil back.

Also added a second DIY gasket to the cap and seems to have helped.

On restart, got smoke from where the header met the head - tightened up the bolts.

Also proved that Ivy's exhaust will NOT fit Red.

Also hooked up both lights for my work space - excellent!












Tuesday, January 2, 2018

Ivy: Brighter Rear

Some odd jobs...

  • Switched up the wiring on Roxy's voltmeter so that it can be plugged/unplugged from outside the batt cover
  • Added 2 funnels of oil to Ivy
  • Tighten Ivy rear brake
  • Realized Ivy's rear bulb was much dimmer than Roxy's, so swapped them.  But then realized that Astrid's bulb was crazy bright but wasn't sure if maybe it was too high a voltage so swapped Astrid's to Roxy.)
  • Tested setting up the light near the old trash door to make a little work area... not bad...







Tuesday, December 12, 2017

Roxy: Digital Age

Hooked up the digital voltmeter to Roxy for full time display.  Snazzy.


Saturday, November 25, 2017

Ivy: Pieces Falling Off, Fun with Electricity

Decided to wire up the headlight/tail light directly off the main switch (so they would be "always on").

Went smoothly and the bike started and idled ok, so figured I was in good shape.

Then also discovered that the bolt holding the exhaust to the head had fallen out!  Replaced it with a stud bolt taken from the model engine.  Had a scary moment when I installed the bolt then couldn't get the exhaust hole to line up.

Ended up having to line up the exhaust first and then screw in the stud bolt.  Question is - will I have to do it that way every time now??


Dec 2nd Ride Report:

The bike felt stronger and smoother which I figured was because of the exhaust not being loose, but it could have been entirely my imagination.

Everything was going great until I got back to 19th and felt it sputtering and hesitating.  Right when I turned for Blue Fin it died completely.  After many tries, finally got it restarted but only lasted a block and died again.

Checking the battery at home and it was down to 5.67 volts, so clearly the lights were too much of a drain.  But this was on SLA #3, which is the weird one since it never goes fully green on the charger.  So is it really the lights draining the battery, or is it just a dud battery?

Needless to say, disconnected the lights for now...








Tuesday, November 21, 2017

Ivy: Torque Checks

Ran through the list of torque settings and checked everything on Ivy.  Everything was still to spec.

Also just mulled over the options for hooking up the headlight/tail light.




Thursday, October 19, 2017

Roxy: SLA Battery

Hooked the SLA battery up to Roxy.