CB100: Fasteners & Hardware

 Added new cylinder studs and installed left and right side engine covers.

 

 

CB100 New Parts

First steps toward a rolling chassis.

New parts: 

• Swingarm (with brake stay)
  
• Top and bottom engine mounts
• Engine bolts
  
• Step bar
  

Swingarm is in good shape and fits the frame.  Looks like the distance between the forks is much wider than the S90 so won't be able to use that rear wheel.  But S90 cushions do fit (at least the mountings, need to check if the length is correct).

Engine mounting plates also fit.  But when fitting the bottom end, found that the two front holes won't line up well enough to get both bolts in.  So left it with the top bolt in.  Think I'd just need to open up the hole on the mount a tiny bit to make it fit, but will leave it for another day.

Discovered that the top mount also has the mounting holes for the ignition coil.

Also first time using the new TSTAK rolling cart, which worked fantastically both to roll the drawers around but also as a garage stool.