Proving that one should always carry zipties!
Going down along Anza on the way home and heard a weird "clinking" noise. After a few blocks, realized it was the headlight rattling because it had lost the right side bolt on the mounting ear.
I thought I'd actually lost the mounting plate itself, so I rode back all the way to where I'd turned but didn't see it. Only after getting off the bike and making a closer inspection did I see that it was still there on the bike, stuck to the rubber. Lucky...
Zip tied the mount back into place. Realized that maybe the zip ties were actually a better way to go than the very fiddly nut and bolt.
Saturday, October 26, 2019
Sunday, October 20, 2019
Red: Headlight Grill Chop #2
Drilled out new 8mm holes in the headlight grill.
Started out with the step bit just to make a solid indentation.
Then switched to the DeWalt bits and just started with the smallest and worked my way up.
Finally, went back to the step bit to clean up the hole and smooth out the edges.
Came out trick.
Mounting was fiddly. Ended up switching to 3 washers for spacers as the ones that came with it were now too wide.
Started out with the step bit just to make a solid indentation.
Then switched to the DeWalt bits and just started with the smallest and worked my way up.
Finally, went back to the step bit to clean up the hole and smooth out the edges.
Came out trick.
Mounting was fiddly. Ended up switching to 3 washers for spacers as the ones that came with it were now too wide.
Labels:
headlight
Saturday, October 12, 2019
Red: Headlight Grill Chop #1
The grill I've had sitting in the closet for years is perfect for the new Dime City headlight as it squares it off and gives it a better profile. Only problem was that the mounting ears were way too long. Not only would I have to drill new mounting holes but the ears themselves needed to get chopped otherwise they'd hit the mounts.
Dremel cutting wheel made short work of it.
Dremel cutting wheel made short work of it.
Labels:
headlight
Saturday, October 5, 2019
Ivy II: Chain Off
Removed Ivy's chain. Disconnected the clutch cable and zip tied that and the carb out of the way.
Testing the headlight grille on Red. Looks like the mounting holes need to get drilled a bit more forward to pull it backwards and close the gap. At least it fits, though.
Labels:
Ivy II
Subscribe to:
Posts (Atom)